Users Guide

interface
ethernet
node/slot/
port[:subport
]
Display the number of MAC addresses learned on the specified interface.
interface
port-channel
number
Display the number of MAC addresses learned on the specified port channel.
vn-id
Display the number of MAC addresses learned on the specified virtual network,
from 1 to 65535.
Default Not configured
Command mode EXEC
Usage
information
Use this command to display the number of MAC address entries learned on virtual networks in the MAC
address table.
Example
OS10# show mac address-table count virtual-network
MAC Entries for all vlans :
Dynamic Address Count : 8
Static Address (User-defined) Count : 0
Total MAC Addresses in Use: 8
Supported
releases
10.4.2.0 or later
show mac address-table extended
Displays MAC addresses learned on all VLANs and VXLANs.
Syntax
show mac address-table extended [address mac-address | interface {ethernet
node/slot/port:subport | port-channel number} | static | dynamic]
Parameters
address mac-
address
Display only information about the specified MAC address.
interface
ethernet
node/slot/
port[:subport
]
Display only MAC addresses learned on the specified interface.
interface
port-channel
number
Display only MAC addresses learned on the specified port channel.
static
Display only static MAC addresses.
dynamic
Display only dynamic MAC addresses.
Default Not configured
Command mode EXEC
Usage
information
By default, MAC learning from a remote VTEP is enabled. Use this command to verify the MAC addresses
learned both on VXLAN virtual networks and VLANs on the switch. The show mac address-table
command displays the MAC addresses learned only on LAN port and VLAN interfaces.
Example
OS10# show mac address-table extended
Virtual-Network VlanId MAC Address Type Interface/Remote-VTEP
----------------------------------------------------------------------------
- 500 00:00:00:00:11:11 dynamic ethernet1/1/31:1
- 500 00:00:00:00:44:44 dynamic port-channel1000
902 VXLAN