Reference Guide

Default Not congured
Command Mode EXEC
Example
OS10# show interface ethernet 1/1/48 eee
Port EEE Status Speed Duplex
---------------------------------------------
Eth 1/1/48 on up 1000M
Supported Releases 10.3.0E or later
show interface ethernet eee statistics
Displays EEE statistics for a specied interface.
Syntax
show interface ethernet node/slot/port[:subport] eee statistics
Parameters node/slot/port[:subport]—Enter the interface information.
Default Not congured
Command Mode EXEC
Example
OS10# show interface ethernet 1/1/48 eee statistics
Eth 1/1/48
EEE : on
TxIdleTime(us) : 2560
TxWakeTime(us) : 5
Last Clearing : 18:45:53
TxEventCount : 0
TxDuration(us) : 0
RxEventCount : 0
RxDuration(us) : 0
Supported Releases 10.3.0E or later
View interface conguration
To view basic interface information, use the show interface, show running-configuration, and show interface status
commands. You can stop scrolling output from a show command by entering CTRL+C. Display information about a physical or virtual
interface in EXEC mode (including up/down status, MAC and IP addresses, and input/output trac counters).
show interface [type]
• phy-eth node/slot/port[:subport] — Display information about physical media connected to the interface.
• status — Display interface status.
• ethernet node/slot/port[:subport] — Display Ethernet interface information.
• loopback id — Display loopback interface information (0 to 16383).
• mgmt node/slot/port — Display Management interface information.
• port-channel id-number — Display port-channel interface information (1 to 128).
• vlan vlan-id — Display the VLAN interface information (1 to 4093).
View interface information
OS10# show interface
Ethernet 1/1/1 is up, line protocol is down
Hardware is Eth, address is 00:0c:29:66:6b:90
Current address is 00:0c:29:66:6b:90
Interfaces
101