Reference Guide
create and disables L3 transmission. The no version of the command disables L2 VLAN scaling. To enable L3
routing trac on a VLAN, use the mode L3 command.
Example
OS10(config)# scale-profile vlan
Supported Releases 10.4.0E(X2) or later
show discovered-expanders
NOTE: This command will be supported in future releases.
Syntax
show discovered-expanders
show interface
Displays interface information.
Syntax
show interface [type]
Parameters interface type — Enter the interface type:
• phy-eth node/slot/port[:subport] — Display information about physical ports connected to the
interface.
• status — Display interface status.
• ethernet node/slot/port[:subport] — Display Ethernet interface information.
• loopback id — Display loopback IDs (0 to 16383).
• mgmt node/slot/port — Display Management interface information.
• null — Display null interface information.
• port-channel id-number — Display port channel interface IDs (1 to 128).
• vlan vlan-id — Display the VLAN interface number (1 to 4093).
Default Not congured
Command Mode EXEC
Usage Information Use the do show interface command to view interface information from other command modes.
Example
OS10# show interface
Ethernet 1/1/2 is up, line protocol is up
Hardware is Dell EMC Eth, address is 00:0c:29:54:c8:57
Current address is 00:0c:29:54:c8:57
Pluggable media present, QSFP+ type is QSFP+ 40GBASE CR 1.0M
Wavelength is 64
Receive power reading is 0.0
Interface index is 17305094
Internet address is not set
Mode of IPv4 Address Assignment: not set
Interface IPv6 oper status: Enabled
Link local IPv6 address: fe80::20c:29ff:fe54:c857/64
Global IPv6 address: 2::1/64
MTU 1532 bytes, IP MTU 1500 bytes
LineSpeed 40G, Auto-Negotiation on
FEC is auto, Current FEC is off
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout: 60
Last clearing of "show interface" counters: 00:40:14
114 Interfaces