Reference Guide

Example (active
zoneset)
OS10# show fc zoneset active
vFabric id: 100
Active Zoneset: set
ZoneName ZoneMember
===========================================================
hba2 20:01:00:0e:1e:e8:e4:99
20:35:78:2b:cb:6f:65:57
50:00:d3:10:00:ec:f9:05
50:00:d3:10:00:ec:f9:1b
50:00:d3:10:00:ec:f9:1f
hba1 *10:00:00:90:fa:b8:22:19
*21:00:00:24:ff:7b:f5:c8
21:00:00:24:ff:7f:ce:ee
21:00:00:24:ff:7f:ce:ef
Example (with
zoneset name)
OS10# show fc zoneset set
ZoneSetName ZoneName ZoneMember
==================================================================
set hba1 21:00:00:24:ff:7b:f5:c8
10:00:00:90:fa:b8:22:19
21:00:00:24:ff:7f:ce:ee
21:00:00:24:ff:7f:ce:ef
hba2 20:01:00:0e:1e:e8:e4:99
50:00:d3:10:00:ec:f9:1b
50:00:d3:10:00:ec:f9:05
50:00:d3:10:00:ec:f9:1f
20:35:78:2b:cb:6f:65:57
Supported Releases 10.3.1E or later
zone default-zone permit
Enables access between all logged-in FC nodes of vfabric in the absence of an active zoneset conguration. A default zone advertises a
maximum of 255 members in the registered state change notication (RSCN) message.
Syntax
zone default-zone permit
Parameters None
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command disables access between FC nodes in the absence of an active zoneset.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zone default-zone permit
Supported Releases 10.3.1E or later
zoneset activate
Activates an existing zoneset. You can activate only one zoneset in a vfabric.
Syntax
zoneset activate zoneset-name
Fibre Channel 137