Reference Guide

Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command removes the VLAN ID from the vfabric.
Example
OS10(config)# interface vlan 1023
10OS10(conf-if-vl-1023)# exit
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# vlan 1023
Supported Releases 10.3.1E or later
FIP-snooping commands
The following commands are supported on FIP-snooping mode:
feature p-snooping
Enables the FIP snooping feature globally.
Syntax
feature fip-snooping
Parameters None
Defaults Disabled
Command Mode CONFIGURATION
Usage Information
The no version of this command disables FIP snooping.
Example
OS10(config)# feature fip-snooping
Supported Releases 10.4.0E(R1) or later
p-snooping enable
Enables FIP snooping on specied VLAN.
Syntax
fip-snooping enable
Parameters None
Defaults Disabled
Command Mode VLAN INTERFACE
Usage Information
The no version of this command disables FIP snooping on the VLAN.
You can enable FIP snooping on a VLAN only after enabling the FIP snooping feature globally using the feature
fip-snooping
command. OS10 supports FIP snooping on a maximum of 12 VLANs.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping enable
Fibre Channel 145