Reference Guide

Example
OS10(conf-mon-erpm-source-10)# ip ttl 16
OS10(conf-mon-erpm-source-10)# ip DSCP 63
Supported Releases 10.4.0E(R1) or later
monitor session
Creates a session for monitoring trac with port monitoring.
Syntax
monitor session session-id type [local | rpm-source | erpm-source]
Parameters
• session-id — Enter a monitor session ID (1 to 18).
• local — (Optional) Enter a local monitoring session.
• rpm-source — (Optional) Enter a remote monitoring session.
• erpm-source — (Optional) Enter an encapsulated remote monitoring session.
Default local
Command Mode CONFIGURATION
Usage Information The no version of this command removes the monitor session.
Example
OS10(config)# monitor session 1
OS10(conf-mon-local-1)#
Example (RPM)
OS10(config)# monitor session 5 type rpm-source
OS10(conf-mon-rpm-source-5)#
Example (ERPM)
OS10(config)# monitor session 10 type erpm-source
OS10(conf-mon-erpm-source-10)#
Supported Releases 10.2.0E or later
show monitor session
Displays information about a monitoring session.
Syntax
show monitor session {session-id | all}
Parameters
• session-id — Enter the session ID number (1 to 18).
• all — View all monitoring sessions.
Default All
Command Mode EXEC
Usage Information In the State eld, true indicates that the port is enabled. In the Reason eld, Is UP indicates that hardware resources are allocated .
Example (specic
session)
OS10# show monitor session 1
S.Id Source Destination Dir Mode Source IP Dest IP DSCP TTL Gre-Protocol State Reason
------------------------------------------------------------------------------------------------------------------------
1 ethernet1/1/1 remote-ip both port 11.11.11.1 11.11.11.11 0 255 35006 true Is UP
264 Layer 2