Reference Guide

(Up): Interface up (Dwn): Interface down (Dis): Interface disabled
Uplink State Group : 1 Status : Enabled,up Name : UFDGROUP1
Defer Time : 10 second(s)
Upstream Interfaces : Eth 1/1/7:1(Up)
Downstream Interfaces: Eth 1/1/1(Dwn) Eth 1/1/2(Dwn) Eth 1/1/3(Dwn) Eth 1/1/4(Dwn)
Eth 1/1/5(Dwn) Eth 1/1/9:2(Dwn) Eth 1/1/9:3(Dwn)
OS10(conf-uplink-state-group-1)# show configuration
!
uplink-state-group 1
downstream ethernet1/1/1-1/1/5
downstream ethernet1/1/9:2-1/1/9:3
upstream ethernet1/1/7:1
UFD commands
clear ufd-disable
Overrides the uplink-state group conguration and brings up the downstream interfaces.
Syntax
clear ufd-disable {interface interface-type | uplink-state-group group-id}
Parameters
• interface-type — Enter the interface type.
• group-id — Enter the uplink state group ID, from 1 to 32.
Default None
Command Mode EXEC
Usage Information This command manually brings up a disabled downstream interface that is in UFD-disabled error state. After the
downstream interface is up, it is not disabled until there are changes in the upstream interfaces. This command
does not have eect on downstream interfaces that are already up or interfaces that are not part of the UFD
group.
Example
OS10# clear ufd-disable interface ethernet 1/1/2
OS10# clear ufd-disable uplink-state-group 1
Supported Releases 10.4.0E(R3) or later
defer-time
Congures timer to defer UFD actions on downstream ports.
Syntax
defer-time timer
Parameters timer— Enter the timer value in seconds, ranging from 1 to 120.
Default Disabled
Command Mode UPLINK-STATE-GROUP
Usage Information You can view the timer details congured using the show uplink-state-group [group-id] detail
command. The no version of this command disables the timer.
System management 549