Reference Guide
DCBX conguration notes
• To exchange link-level congurations in a converged network, DCBX is a prerequisite for using DCB features, such as PFC and ETS.
DCBX is also deployed in topologies that support lossless operation for FCoE or iSCSI trac. In these scenarios, all network devices
must be DCBX-enabled so that DCBX is enabled end-to-end.
• DCBX uses LLDP to advertise and automatically negotiate the administrative state and PFC/ETS conguration with directly connected
DCB peers. If you disable LLDP on an interface, DCBX cannot run. Enable LLDP on all DCBX ports,
• DCBX is disabled at a global level by default. Enable DCBX globally on a switch to activate the exchange of DCBX TLV messages with
PFC, ETS, and iSCSI congurations.
• DCBX is enabled by default on OS10 interfaces. You can manually recongure DCBX settings on a per-interface basis. For example, you
can disable DCBX on an interface (no lldp tlv-select dcbxp command) or change the DCBX version (dcbx version
command).
• For DCBX to be operational, DCBX must be enabled at both the global and interface levels. If the show lldp dcbx interface
command returns the message DCBX feature not enabled, DCBX is not enabled at both levels.
• OS10 supports DCBX versions: CEE and IEEE2.5.
• By default, DCBX advertises all TLVs—PFC, ETS Recommendation, ETS Conguration, DCBXP, and basic TLVs.
• A DCBX-enabled port operates in a manual role by default. The port operates only with user-congured settings and does not auto-
congure with DCB settings received from a DCBX peer. When you enable DCBX, the port advertises its PFC and ETS congurations
to peer devices but does not accept external, or propagate internal, DCB congurations.
• DCBX detects misconguration on a peer device when DCB features are not compatibly congured with the local switch.
Misconguration detection is feature-specic because some DCB features support asymmetric (non-identical) congurations.
Congure DCBX
DCBX allows data center devices to advertise and exchange conguration settings with directly connected peers using LLDP. LLDP is
enabled by default.
To ensure the consistent and ecient operation of a converged data center network, DCBX detects peer misconguration.
DCBX is disabled at a global level and enabled at an interface level by default. For DCBX to be operational, DCBX must be enabled at both
the global and interface levels. You can manually recongure DCBX settings or disable DCBX on a per-interface basis.
1 Congure the DCBX version used on a port in INTERFACE mode.
dcbx version {auto | cee | ieee}
754
Converged data center services