Reference Guide
speed 32
vfabric 100
OS10# show interface fibrechannel 1/1/43:1
Fibrechannel 1/1/43:1 is up, FC link is up
Address is 14:18:77:20:8d:fc, Current address is 14:18:77:20:8d:fc
Pluggable media present, QSFP+ type is QSFP+ 4x(16GBASE FC SW)
Wavelength is 850
Receive power reading is 0.0
FC MTU 2188 bytes
LineSpeed 8G
Port type is F, Max BB credit is 1
WWN is 20:78:14:18:77:20:8d:cf
Last clearing of "show interface" counters: 00:02:32
Input statistics:
33 frames, 3508 bytes
0 class 2 good frames, 33 class 3 good frames
0 frame too long, 0 frame truncated, 0 CRC
1 link fail, 0 sync loss
0 primitive seq err, 0 LIP count
0 BB credit 0, 0 BB credit 0 packet drops
Output statistics:
33 frames, 2344 bytes
0 class 2 frames, 33 class 3 frames
0 BB credit 0, 0 oversize frames
6356027325 total errors
Rate Info:
Input 116 bytes/sec, 1 frames/sec, 0% of line rate
Output 78 bytes/sec, 1 frames/sec, 0% of line rate
Time since last interface status change: 00:00:24
Management interface
The Management interface provides OOB management access to the network device. You can congure the Management interface, but
the conguration options on this interface are limited. You cannot congure gateway addresses and IP addresses if it appears in the main
routing table, and proxy ARP is not supported on this interface.
1 Congure the Management interface in CONFIGURATION mode.
interface mgmt 1/1/1
2 By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode.
no ip address dhcp
3 Congure an IP address and mask on the Management interface in INTERFACE mode.
ip address A.B.C.D/prefix-length
4 Enable the Management interface in INTERFACE mode.
no shutdown
Congure management interface
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# no ip address dhcp
OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24
OS10(conf-if-ma-1/1/1)# no shutdown
VLAN interfaces
VLANs are logical interfaces and are, by default, in L2 mode. Physical interfaces and port-channels can be members of VLANs.
OS10 supports inter-VLAN routing. You can add IP addresses to VLANs and use them in routing protocols in the same manner that physical
interfaces are used.
Interfaces
85