Users Guide

seq deny
Assigns a sequence number to deny IPv4 addresses while creating the filter.
Syntax
seq sequence-number deny [protocol-number | icmp | ip | tcp | udp] [A.B.C.D
| A.B.C.D/x | any | host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-
address] [capture | count | dscp value | fragment | log]
Parameters
● sequence-number — Enter the sequence number to identify the ACL for editing and sequencing
number, from 1 to 16777214.
● protocol-number — (Optional) Enter the protocol number, from 0 to 255.
● icmp — (Optional) Enter the ICMP address to deny.
● ip — (Optional) Enter the IPv4 address to deny.
● tcp — (Optional) Enter the TCP address to deny.
● udp — (Optional) Enter the UDP address to deny.
● A.B.C.D — (Optional) Enter the IPv4 address in dotted decimal format.
● A.B.C.D/x — (Optional) Enter the number of bits that must match the dotted decimal address.
● any — (Optional) Enter the keyword any to specify any source or destination IP address.
● host ip-address — (Optional) Enter the IPv4 address to use a host address only.
● capture — (Optional) Capture packets the filter processes.
● count — (Optional) Count packets the filter processes.
● byte — (Optional) Count bytes the filter processes.
● dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
● fragment — (Optional) Use ACLs to control packet fragments.
● log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not configured
Command Mode IPV4-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes
increment. The no version of this command removes the filter, or use the no seq sequence-number
command if you know the filter’s sequence number.
Example
OS10(config)# ip access-list testflow
OS10(conf-ipv4-acl)# seq 10 deny tcp any any capture session 1 log
Supported
Releases
10.2.0E or later
seq deny (IPv6)
Assigns a sequence number to deny IPv6 addresses while creating the filter.
Syntax
seq sequence-number deny [protocol-number icmp | ip | tcp | udp] [A::B |
A::B/x | any | host ipv6-address] [A::B | A::B/x | any | host ipv6-address]
[capture | count | dscp value | fragment | log]
Parameters
● sequence-number — Enter the sequence number to identify the route-map for editing and
sequencing number, from 1 to 16777214.
● protocol-number — (Optional) Enter the protocol number, from 0 to 255.
● icmp — (Optional) Enter the ICMP address to deny.
● ip — (Optional) Enter the IPv6 address to deny.
● tcp — (Optional) Enter the TCP address to deny.
● udp — (Optional) Enter the UDP address to deny.
● A::B — Enter the IPv6 address in hexadecimal format separated by colons.
● A::B/x — Enter the number of bits that must match the IPv6 address.
● any — (Optional) Enter the keyword any to specify any source or destination IP address.
1274 Access Control Lists