Users Guide

Example
OS10(config)# route-map bgp
OS10(conf-route-map)# match route-type external type-1
Supported
Releases
10.3.0E or later
match tag
Configures a filter to redistribute only routes that match a specific tag value.
Syntax
match tag tag-value
Parameters tag-value — Enter the tag value to match with the tag number, from 0 to 4294967295.
Default Not configured
Command Mode ROUTE-MAP
Usage
Information
The no version of this command deletes the match.
Example
OS10(conf-route-map)# match tag 656442
Supported
Releases
10.2.0E or later
route-map
Enables a route-map statement and configures its action and sequence number.
Syntax
route-map map-name [permit | deny | sequence-number]
Parameters
● map-name — Enter the name of the route-map. A maximum of 140 characters.
● sequence-number — (Optional) Enter the number to identify the route-map for editing and
sequencing number from 1 to 65535. The default is 10.
● permit — (Optional) Set the route-map default as permit.
● deny — (Optional) Set the route default as deny.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
NOTE: Exercise caution when you delete route-maps — if you do not enter a sequence number, all
route-maps with the same map-name are deleted.
The no version of this command removes a route-map.
Example
OS10(config)# route-map route1 permit 100
OS10(config-route-map)#
Supported
Releases
10.2.0E or later
set comm-list add
Add communities in the specified list to the COMMUNITY attribute in a matching inbound or outbound BGP route.
Syntax
set comm-list {community-list-name} add
Parameters community-list-name — Enter the name of an established community list. A maximum of 140
characters.
Access Control Lists 1301