Users Guide

DHCP server commands
default-router address
Assigns a default gateway to clients based on the IP address pool.
Syntax
default-router address [address2...address8]
Parameters
● address — Enter an IPv4 or IPv6 address to use as the default gateway for clients on the subnet in
A.B.C.D or A:B format.
● address2...address8 — (Optional) Enter up to eight IP addresses, in order of preference.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
Configure up to eight IP addresses, in order of preference. Use the no version of this command to
remove the configuration.
Example
OS10(conf-dhcp-pool2)# default-router 20.1.1.100
Supported
Releases
10.2.0E or later
disable
Disables the DHCP server.
Syntax
disable
Parameters None
Default Disabled
Command Mode DHCP
Usage
Information
The no version of this command enables the DHCP server.
Example
OS10(conf-dhcp)# no disable
Supported
Releases
10.2.0E or later
domain-name
Configures the name of the domain where the device is located.
Syntax
domain-name domain-name
Parameters domain-name — Enter the name of the domain with a maximum of 32 characters.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
This is the default domain name that appends to hostnames that are not fully qualified. The no version of
this command removes the configuration.
Example
OS10(conf-dhcp-Dell)# domain-name dell.com
Supported
Releases
10.2.0E or later
System management 231