Users Guide

dns-server address
Assigns a DNS server to clients based on the address pool.
Syntax
dns-server address [address2...address8]
Parameters
● address — Enter the DNS server IP address that services clients on the subnet in A.B.C.D or A::B
format.
● address2...address8 — (Optional) Enter up to eight DNS server addresses, in order of
preference.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
None
Example
OS10(conf-dhcp-Dell)# dns-server 192.168.1.1
Supported
Releases
10.2.0E or later
hardware-address
Configures the client's hardware address for manual configurations.
Syntax
hardware-address nn:nn:nn:nn:nn:nn
Parameters nn:nn:nn:nn:nn:nn — Enter the 48-bit hardware address.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
The client hardware address is the MAC address of the client machine used for manual address binding.
Example
OS10(conf-dhcp-static)# hardware-address 00:01:e8:8c:4d:0a
Supported
Releases
10.2.0E or later
host
Assigns a host to a single IPv4 or IPv6 address pool for manual configurations.
Syntax
host A.B.C.D/A::B
Parameters A.B.C.D/A::B — Enter the host IP address in A.B.C.D or A::B format.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
The host address is the IP address that a client machine uses for DHCP.
Example
OS10(conf-dhcp-Dell)# host 20.1.1.100
Supported
Releases
10.2.0E or later
232 System management