Users Guide

Default Not configured
Command Mode Global config
Usage
Information
Time to wait after the last FCF connects to the NPG switch to send the Multicast discovery
Advertisement. This command is supported in NPG mode.
Example
OS10(config)# fcoe delay fcf-adv 16
Supported
Releases
10.4.0E(R1) or later In previous releases, the command is not available in full switch mode. From this
release, the command is available both in full switch mode and fabric mode.
name
Configures a vfabric name.
Syntax
name vfabric-name
Parameters vfabric-name — Enter a name for the vfabric.
Defaults Not configured
Command Mode Vfabric CONFIGURATION
Usage
Information
The no version of this command removes the vfabric name..
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# name test_vfab
Supported
Releases
10.3.1E or later
Re-balance the FC sessions
Re-balances the FC sessions across FC uplinks.
Syntax
re-balance fc npg sessions vfabric vfabric-id [dry-run][brief]
Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
Triggers the load-balancing mechanism to redistribute the sessions across the FC uplinks.
The dry-run option displays the current state of the system, sessions that are cleared, and the system state after the load
balancing is done without actually doing it. You can use the brief option (both in dry run and actual run) to view only the
session redistribution information.
You can configure fcoe delay fcf-adv timer that is based on the switch configuration to balance the system during
reload. Even if the system is unbalanced after reload, you can use this command in the switch to balance the sessions, within
the uplinks.
This command is supported in the NPG mode.
The following table lists the fields and descriptions that are displayed in this command:
Table 21. Fields and Descriptions
Fields Description
Uplink Intf The name of the FC uplink interface
FLOGI Number of Fabric Login Sessions in the FC uplink interface
Fibre Channel 411