Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4112F-ON/S4112T-ON
41424344454647484950
Table Of Contents
OS Version: 10.5.0.0
Build Version: 10.5.0.270
Build Time: 2019-07-29T23:35:01+0000
System Type: S4148F-ON
Architecture: x86_64
Up Time: 1 day 00:54:13
9. Apply the saved configuration and license files, and reload the switch.
OS10# copy ftp://userid:passwd@hostip/filepath/10.5.0.0-startup.xml config://
startup.xml
OS10# license install scp://user:passwd@hostip/0A900Q2-NOSEnterprise-License.xml
OS10# reload
NOTE: While reloading, if the CLI prompts to save, select no for the save option. Selecting yes overrides the
configuration that was saved earlier.
Roll back from 10.5.1.0 or later release to 10.5.0.0 or earlier release
Use the rollback script that is bundled with your OS10 software image to move to an earlier release. Using the rollback script
retains the earlier configuration and license information. You can use the rollback option only when the previous image is
available in the system as the standby image. Use the show boot detail command to view the version of the standby
image.
NOTE: The rollback script reboots the OS10 switch immediately.
To roll back, from the Linux shell prompt, enter:
OS10# system bash
bash (OS10) $ sudo os10-rollback-to-old-image
NOTE:
After rollback is complete, the system comes up with the previous release. However, the standby image becomes
nonbootable. To boot using the standby image, you have to install the image again using the image install command.
Switch deployment options
After you log in to OS10, configure the switch:
● Manually by using the command-line interface.
● Automatically using zero-touch deployment (ZTD).
● Automatically using customized scripts with Ansible.
Manual CLI configuration
Use the OS10 command-line interface to enter commands to monitor and configure an OS10 switch. Set up your switch by
performing basic and advanced CLI tasks — CLI basics and Advanced CLI tasks. Then proceed with other configuration settings
according to how you deploy the switch in your network. For detailed configuration and CLI information, refer to the appropriate
chapter.
ZTD-automated switch deployment
Automate OS10 switch deployment using zero-touch deployment, including:
● Upgrade an existing OS10 image.
● Execute a CLI batch file to configure the switch.
● Execute a post-ZTD script to perform additional functions.
50
Getting Started with Dell EMC SmartFabric OS10