Users Guide

ip
Configures the IP time-to-live (TTL) value and the differentiated services code point (DSCP) value for the ERPM traffic.
Syntax
ip {ttl ttl-number | dscp dscp-number}
Parameters
● ttl-number—Enter the TTL value, from 1 to 255.
● dscp-number—Enter the DSCP value, from 0 to 63.
Default
● TTL: 255
● DSCP: 0
Command Mode MONITOR-SESSION (ERPM)
Usage
Information
The no version of this command removes the configured TTL and DSCP values.
This command is introduced on the MX9116n and MX5108n with support for full-switch mode from the
Dell EMC SmartFabric OS release 10.4.0(R3S). Also supported in SmartFabric Services mode on the
MX9116n and MX5108n from the Dell EMC SmartFabric OS release 10.5.1.
Example
OS10(conf-mon-erpm-source-10)# ip ttl 16
OS10(conf-mon-erpm-source-10)# ip DSCP 63
Supported
Releases
10.4.0E(R1) or later
monitor session
Creates a session for monitoring traffic with port monitoring.
Syntax
monitor session session-id type [local | rpm-source | erpm-source]
Parameters
● session-id—Enter a monitor session ID, from 1 to 18.
● local—(Optional) Enter a local monitoring session.
● rpm-source—(Optional) Enter a remote monitoring session.
● erpm-source—(Optional) Enter an encapsulated remote monitoring session.
Default local
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the monitor session.
This command is introduced on the MX9116n and MX5108n with support for full-switch mode from the
Dell EMC SmartFabric OS release 10.4.0(R3S). Also supported in SmartFabric Services mode on the
MX9116n and MX5108n from the Dell EMC SmartFabric OS release 10.5.1.
Example
OS10(config)# monitor session 1
OS10(conf-mon-local-1)#
Example (RPM)
OS10(config)# monitor session 5 type rpm-source
OS10(conf-mon-rpm-source-5)#
Example (ERPM)
OS10(config)# monitor session 10 type erpm-source
OS10(conf-mon-erpm-source-10)#
Supported
Releases
10.2.0E or later
562 Layer 2