Reference Guide

spanning-tree port
Sets the port type as the EdgePort.
Syntax
spanning-tree port type edge
Parameters None
Default Not configured
Command Mode INTERFACE
Usage
Information
When you configure an EdgePort on a device running STP, the port immediately transitions to Forwarding
state. Only configured ports connected to end hosts act as EdgePorts.
Example
OS10(config)# spanning-tree port type edge
Supported
Releases
10.2.0E or later
spanning-tree rstp force-version
Configures a forced version of spanning tree to transmit BPDUs.
Syntax
spanning-tree rstp force-version stp
Parameters stp — Force the version for the BPDUs transmitted by RSTP.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
Forces a bridge that supports RSTP or MST to operate in a STP-compatible manner to avoid frame
misordering and duplication in known LAN protocols that are sensitive.
Example
OS10(config)# spanning-tree rstp force-version stp
Supported
Releases
10.2.0E or later
spanning-tree rstp forward-time
Configures a time interval for the interface to wait in the Blocking state or the Learning state before moving to the Forwarding
state.
Syntax
spanning-tree rstp forward-time seconds
Parameters seconds — Enter the number of seconds an interface waits in the Blocking or Learning States before
moving to the Forwarding state (4 to 30).
Default 15 seconds
Command Mode CONFIGURATION
Usage
Information
None
Example
OS10(config)# spanning-tree rstp forward-time 16
Supported
Releases
10.2.0E or later
234 Layer 2