Reference Guide

seq deny (IPv6)
Assigns a sequence number to deny IPv6 addresses while creating the filter.
Syntax
seq sequence-number deny [protocol-number icmp | ip | tcp | udp] [A::B |
A::B/x | any | host ipv6-address] [A::B | A::B/x | any | host ipv6-address]
[capture | dscp value | fragment]
Parameters
● sequence-number — Enter the sequence number to identify the route-map for editing and
sequencing number, from 1 to 16777214.
● protocol-number — (Optional) Enter the protocol number, from 0 to 255.
● icmp — (Optional) Enter the ICMP address to deny.
● ip — (Optional) Enter the IP address to deny.
● tcp — (Optional) Enter the TCP address to deny.
● udp — (Optional) Enter the UDP address to deny.
● A::B — Enter the IPv6 address in hexadecimal format separated by colons.
● A::B/x — Enter the number of bits that must match the IPv6 address.
● any — (Optional) Determine route types:
○ capture — (Optional) Enter to capture packets the filter processes.
○ dscp value — (Optional) Enter to deny a packet based on the DSCP values, from 0 to 63.
○ fragment — (Optional) Enter to use ACLs to control packet fragments.
● host ipv6-address — (Optional) Enter to use an IPv6 host address only.
Default Not configured
Command Mode IPV6-ACL
Usage
Information
The no version of this command removes the filter, or use the no seq sequence-number command if
you know the filter’s sequence number.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# seq 5 deny ipv6 any any capture session 1 count
Supported
Releases
10.2.0E or later
seq deny (MAC)
Assigns a sequence number to a deny filter in a MAC access list while creating the filter.
Syntax
seq sequence-number deny {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any}
{nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture |
cos | vlan]
Parameters
● sequence-number — Enter the sequence number to identify the route-map for editing and
sequencing number, from 1 to 16777214.
● nn:nn:nn:nn:nn:nn — Enter the source MAC address.
● 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not
enter a mask, a mask of 00:00:00:00:00:00 applies.
● any — (Optional) Set all routes which are subject to the filter:
○ protocol-number — Protocol number identified in the MAC header, from 600 to ffff.
○ capture — (Optional) Capture packets the filter processes.
○ cos — (Optional) CoS value, from 0 to 7.
○ vlan — (Optional) VLAN number, from 1 to 4093.
Default Not configured
Command Mode CONFIG-MAC-ACL
Usage
Information
The no version of this command removes the filter, or use the no seq sequence-number command if
you know the filter’s sequence number.
598 Access Control Lists