Reference Guide

● System-qos level
OS10(config-sys-qos)# trust-map dscp default
ACL based classification
Classify the ingress traffic by matching the packet fields using ACL entries.
You can classify the traffic flows based on QoS specific fields or generic fields, using IP or MAC ACLs. Create class-map
template to match the fields.
OS10 allows matching any of the fields or all the fields based on the match type configured in the class-map.
Use access-group match filter to match MAC or IP ACLs. You can configure a maximum of 4 access-group filters in a class-map:
● 802.1p CoS
● VLAN ID (802.1.Q)
● DSCP + ECN
● IP precedence
OS10 supports configuring a range of or comma separated values of match filters. When you apply the same match filter with
new values, the system overwrites the previous values with the new values.
Configure ACL based classification
1. Create a class-map of type qos.
OS10(config)# class-map cmap
2. Define the fields to be matched, based on:
● 802.1p CoS
OS10(config-cmap-qos)# match cos 0,4-7
● all the 802.1p CoS values excluding a few
OS10(config-cmap-qos)# match not cos 3,4
● VLAN ID (range of or comma separated VLAN match is not supported)
OS10(config-cmap-qos)# match vlan 100
● IP DSCP
OS10(config-cmap-qos)# match ip dscp 3,5,20-30
● IP DSCP + ECN
OS10(config-cmap-qos)# match ip dscp 3,5,20-30 ecn 2
● IP precedence
OS10(config-cmap-qos)# match ip precedence 2
● IPv6 DSCP
OS10(config-cmap-qos)# match ipv6 dscp 3,5,20-30
● IPv6 DSCP + ECN
OS10(config-cmap-qos)# match ipv6 dscp 3,5,20-30 ecn 2
● IPv6 precedence
OS10(config-cmap-qos)# match ipv6 precedence 2
● any IP (IPv4 or IPv6) precedence
OS10(config-cmap-qos)# match ip-any precedence 2
Quality of service
631