Reference Guide

Parameter priority-bitmap — Enter a bitmap value for the dot1p priority advertised for iSCSI traffic in iSCSI
application TLVs (0x1 to 0xff).
Default 0x10 (dot1p 4)
Command Mode CONFIGURATION
Usage
Information
iSCSI traffic uses dot1p priority 4 in frame headers by default. Use this command to reconfigure the
dot1p-priority bits advertised in iSCSI application TLVs. Enter only one dot1p-bitmap value — setting
more than one bitmap value with this command is not supported. The default dot1p 4 value is advertised
only if you enabled PFC pause frames for dot1p 4 traffic (pfc-cos dot1p-priority command). The
no version of this command resets to the default value.
Example
OS10(config)# iscsi priority-bits 0x20
Supported
Releases
10.3.0E or later
iscsi profile-storage
Configures a port for direct connection to a storage device that is not automatically detected by iSCSI.
Syntax
iscsi profile-storage storage-device-name
Parameter storage-device-name — Enter a user-defined name of a storage array that iSCSI does not
automatically detect.
Default Not configured
Command Mode INTERFACE
Usage
Information
Configure directly attached storage arrays to be supported by iSCSI if they are not automatically
detected. This command is required for storage devices that do not support LLDP. The no version of
this command disables the connection.
Example
OS10(conf-if-eth1/1/2)# iscsi profile-storage compellant
Supported
Releases
10.3.0E or later
iscsi session-monitoring enable
Enables iSCSI session monitoring.
Syntax
iscsi session-monitoring enable
Parameter None
Default Disabled
Command Mode CONFIGURATION
Usage
Information
Use the iscsi aging time command to configure the aging timeout in iSCSI monitoring sessions, and
use the iscsi target port command to configure the TCP ports that listen for connected storage
devices in iSCSI monitoring sessions. The no version of this command disables iSCSI session monitoring.
NOTE: When iSCSI session monitoring is enabled, you can monitor a maximum of 100 connections.
Example
OS10(config)# iscsi session-monitoring enable
Supported
Releases
10.3.0E or later
Converged data center services 729