Users Guide

ip pim ssm-range
Specifies the SSM group range using an access list.
Syntax
ip pim [vrf vrf-name] ssm-range {access-list-name}
Parameters
● vrf vrf-name—Enter the keyword vrf, then the name of the VRF.
● access-list-name—Enter the name of the access list.
Default 232.0.0.0/8
Command Mode CONFIGURATION
Usage
Information
When ACL rules change, the ACL and PIM modules apply the new rules automatically. When you remove
the SSM ACL, PIM-SSM is supported only for the default SSM range.
Example
OS10# configure terminal
OS10(config)# ip pim ssm-range ssm
Supported
Releases
10.4.3.0 or later
show ip pim bsr-router
Displays information about the bootstrap router.
Syntax
show ip pim [vrf vrf-name] bsr-router
Parameters vrf vrf-name—Enter the keyword vrf, then the name of the VRF.
Default None
Command Mode EXEC
Usage
Information
None
Example
OS10# show ip pim bsr-router
PIMv2 Bootstrap information
BSR address: 101.0.0.1
BSR Priority: 199, Hash mask length: 31
Expires: 00:00:24
This system is a candidate BSR
Candidate BSR address: 104.0.0.1, priority: 99, hash mask length: 31
Next Cand_RP_advertisement in 00:00:15
RP: 104.0.0.1(loopback101)
Supported
Releases
10.5.0 or later
show ip pim interface
Displays information about IP PIM-enabled interfaces.
Syntax
show ip pim [vrf vrf-name] interface
Parameters vrf vrf-name—Enter the keyword vrf, then the name of the VRF.
Default None
Command Mode EXEC
Usage
Information
The show ip pim interface command displays the following:
● Address—IP addresses of the IP PIM-enabled interfaces
1084 Multicast