Users Guide

Example (active
zoneset)
OS10# show fc zoneset active
vFabric id: 100
Active Zoneset: set
ZoneName ZoneMember
===========================================================
hba2 20:01:00:0e:1e:e8:e4:99
20:35:78:2b:cb:6f:65:57
50:00:d3:10:00:ec:f9:05
50:00:d3:10:00:ec:f9:1b
50:00:d3:10:00:ec:f9:1f
hba1 *10:00:00:90:fa:b8:22:19
*21:00:00:24:ff:7b:f5:c8
21:00:00:24:ff:7f:ce:ee
21:00:00:24:ff:7f:ce:ef
Example (with
zoneset name)
OS10# show fc zoneset set
ZoneSetName ZoneName ZoneMember
==================================================================
set hba1 21:00:00:24:ff:7b:f5:c8
10:00:00:90:fa:b8:22:19
21:00:00:24:ff:7f:ce:ee
21:00:00:24:ff:7f:ce:ef
hba2 20:01:00:0e:1e:e8:e4:99
50:00:d3:10:00:ec:f9:1b
50:00:d3:10:00:ec:f9:05
50:00:d3:10:00:ec:f9:1f
20:35:78:2b:cb:6f:65:57
Supported
Releases
10.3.1E or later
zone default-zone permit
Enables access between all logged-in FC nodes of the vfabric in the absence of an active zoneset configuration.
Syntax
zone default-zone permit
Parameters None
Defaults Not configured
Command Mode Vfabric CONFIGURATION
Usage
Information
A default zone advertises a maximum of 255 members in the registered state change notification (RSCN)
message. The no version of this command disables access between the FC nodes in the absence of an
active zoneset.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zone default-zone permit
Supported
Releases
10.3.1E or later
zoneset activate
Activates an existing zoneset. You can activate only one zoneset in a vfabric.
Syntax
zoneset activate zoneset-name
Parameters zoneset-name — Enter an existing zoneset name.
494 Fibre Channel