Users Guide

router-lifetime
Verifies the configured router lifetime value in the received RA packets.
Syntax
router-lifetime value
Parameters value—Enter the router lifetime in seconds, from 0 to 9000.
Default None
Command Mode RA GUARD POLICY LIST CONFIGURATION
Usage
Information
The no form of this command removes the configuration.
Example
OS10(conf-ra_guard_policy_list)# router-lifetime 100
Supported
Releases
10.5.2.0 or later
router-preference maximum
Verifies the advertised Default Router Preference (DRP) value.
Syntax
router-preference maximum {high | low | medium}
Parameters
● high—Enter high to set the DRP value as high.
● low—Enter low to set the DRP value as low.
● medium—Enter medium to set the DRP value as medium.
Default None
Command Mode RA GUARD POLICY LIST CONFIGURATION
Usage
Information
The DRP value is lower than or equal to the specified limit. If you do not configure this command, the
system bypasses this verification. The no form of this command removes the configuration.
Example
OS10(conf-ra_guard_policy_list)# router-preference maximum high
Supported
Releases
10.5.2.0 or later
show config
Displays the RA guard policy mode configurations.
Syntax
show config
Parameters None
Command Mode RA GUARD POLICY LIST CONFIGURATION
Usage
Information
This command displays the following information about the applied RA guard policy:
● Device role
● Hop limit
● MTU
● Other configuration parameter flag
● Reachability time
● Retransmission timer value
● Router preference value
Example
OS10(conf-ra_guard_policy_list)# show config
!
ipv6 nd ra-guard policy test
918 Layer 3