Users Guide

Table Of Contents
Parameters None
Defaults None
Command Mode INTERFACE
Usage
Information
Use this command to disable and re-enable IPv6 forwarding on an interface for security purposes or to
recover from a duplicate address discovery (DAD) failure. The no version of this command disables IPv6
forwarding.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ipv6 address 2111:dddd:0eee::22/128
OS10(conf-if-eth1/1/1)# no ipv6 enable
OS10(conf-if-eth1/1/1)# ipv6 enable
Supported
Releases
10.3.0E or later
ipv6 address eui-64
Configures a global IPv6 address on an interface by entering only the network prefix and length.
Syntax
ipv6 address ipv6-prefix/prefix-length eui-64
Parameters ipv6-prefix Enter an IPv6 prefix in x:x::y/mask format.
Defaults None
Command Mode INTERFACE
Usage
Information
Use this command to manually configure an IPv6 address in addition to the link-local address generated
with stateless autoconfiguration. Specify only the network prefix and length. The 64-bit interface ID
automatically computes from the MAC address. This command enables IPv6 processing on the interface.
The no version of this command removes the IPv6 address configuration.
Example
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# ipv6 address 2111:dddd:0eee::/64 eui-64
Supported
Releases
10.4.0E(R1) or later
ipv6 address link-local
Configures a link-local IPv6 address on the interface to use instead of the link-local address that is automatically configured with
stateless autoconfiguration.
Syntax
ipv6 address ipv6-prefix link-local
Parameters ipv6-prefix Enter an IPv6 prefix in x:x::y/mask format.
Defaults None
Command Mode INTERFACE
Usage
Information
An interface can have only one link-local address. By default, an IPv6 link-local address
automatically generates with a MAC-based EUI-64 interface ID when a router boots up and
IPv6 is enabled. Use this command to manually configure a link-local address to replace the
autoconfigured address. For example, to configure a more user-friendly link-local address, replace
fe80::eef4:bbff:fefb:fa30/64 with fe80::1/64.
The no version of this command removes the specified link-local address.
Example
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# ipv6 address 2111:dddd:0eee::22/64 link-local
Layer 3 923