Connectivity Guide

zoneset activate
Activates an existing zoneset. You can activate only one zoneset in a vfabric.
Syntax
zoneset activate zoneset-name
Parameters zoneset-name — Enter an existing zoneset name.
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
After you disable an active zoneset, the zone default-zone permit command conguration takes eect.
Based on this conguration, the default zone allows or denies access between all the logged-in FC nodes of the
vfabric. The no version of this command deactivates the zoneset.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zoneset activate set
Supported Releases 10.3.1E or later
NPG commands
The following commands are supported on NPG mode:
fc port-mode F
Congures port mode on Fibre Channel interfaces.
Syntax
fc port-mode F
Parameters None
Defaults N_Port
Command Mode Fibre Channel INTERFACE
Usage Information Congure the port mode when the port is in Shut mode and when NPG mode is enabled. The no version of this
command returns the port mode to default.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# fc port-mode F
Supported Releases 10.4.1.0 or later
feature fc npg
Enables the NPG mode globally.
Syntax
feature fc npg
Parameters None
Defaults Disabled
148 Fibre Channel