Connectivity Guide

Table Of Contents
OS10(conf-if-eth1/1/1)#
OS10(config-router-bgp-neighbor-af)# Apr 27 01:39:03 OS10 dn_sm[2065]: Node.1-Unit.1:PRI:alert
[os10:event],
%Dell EMC (OS10) %BGP_NBR_BKWD_STATE_CHG: Backward state change occurred Hold Time expired for
Nbr:3.1.1.3 VRF:default
Apr 27 01:39:03 OS10 dn_sm[2065]: Node.1-Unit.1:PRI:alert [os10:event], %Dell EMC (OS10)
%BGP_NBR_BKWD_STATE_CHG: Backward
state change occurred Hold Time expired for Nbr:3::3 VRF:default
Passive peering
When you enable a peer-template, the system sends an OPEN message to initiate a TCP connection. If you enable passive peering for the
peer template, the system does not send an OPEN message but responds to an OPEN message.
When a BGP neighbor connection with authentication rejects a passive peer-template, the system prevents another passive peer-template
on the same subnet from connecting with the BGP neighbor. To work around this constraint, change the BGP conguration or change the
order of the peer template conguration.
You can restrict the number of passive sessions the neighbor accepts using the limit command.
1 Enable BGP and assign the AS number to the local BGP speaker in CONFIGURATION mode (1 to 65535 for 2-byte, 1 to 4294967295
for 4-byte).
router bgp as-number
2 Congure a template that does not initiate TCP connections with other peers in ROUTER-BGP mode. A maximum of 16 characters.
template template-name
3 Create and enter the AS number for the remote neighbor in ROUTER-BGP-TEMPLATE mode (1 to 4294967295).
remote-as as-number
4 Enable peer listening and enter the maximum dynamic peers count in ROUTER-BGP-TEMPLATE mode (1 to 4294967295).
listen neighbor ip-address limit
Only after the peer template responds to an OPEN message sent on the subnet does the state of its BGP change to ESTABLISHED. After
the peer template is ESTABLISHED, the peer template is the same as any other peer template, see Peer templates.
If you do not congure a BGP device in Peer-Listening mode, a session with a dynamic peer comes up. Passwords are not supported on
BGPv4/v6 dynamic peers.
Congure passive peering
OS10(config)# router bgp 10
OS10(conf-router-bgp-10)# template bgppg
OS10(conf-router-template)# remote-as 100
OS10(conf-router-template)# listen 32.1.0.0/8 limit 10
Local AS
During BGP network migration, you can maintain existing AS numbers. Recongure your routers with the new information to disable after
the migration. Network migration is not supported on passive peer templates. You must congure Peer templates before assigning it to an
AS.
1 Enter a neighbor IP address, A.B.C.D, in ROUTER-BGP mode.
neighbor ip-address
2 Enter a local-as number for the peer, and the AS values not prepended to announcements from the neighbors in ROUTER-
NEIGHBOR mode (1 to 4294967295).
local-as as number [no prepend]
3 Return to ROUTER-BGP mode.
exit
342
Layer 3