Reference Guide
PBR commands
clear route-map pbr-statistics
Clears all PBR counters.
Syntax
clear route-map [map-name] pbr-statistics
Parameters map-name—Enter the name of a congured route-map (up to 140 characters).
Defaults None
Command Mode EXEC
Usage Information Use the clear route-map pbr-statistics command to clear all PBR counters.
Example
OS10# clear route-map map1 pbr-statistics
Supported Releases 10.3.0E or later
match address
Matches the access-list to the route-map.
Syntax
match {ip | ipv6} address [name]
Parameters name—Enter the name of an access-list (up to 140 characters).
Defaults Not congured
Command Mode ROUTE-MAP
Usage Information None
Example
OS10(conf-route-map)# match ip address acl1
Supported Releases 10.3.0E or later
policy route-map
Assigns a route-map for IPv4 or IPV6 policy-based routing to the interface.
Syntax
{ip | ipv6} policy route-map [map-name]
Parameters map-name—Enter the name of a congured route-map (up to 140 characters).
Defaults Not congured
Command Mode INTERFACE
Usage Information None
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ip policy route-map map1
Supported Releases 10.3.0E or later
Layer 3 407