Reference Guide
Breakout auto-conguration
You can globally enable front-panel Ethernet ports to automatically detect SFP pluggable media in a QSFP+ or QSFP28 port. The port
autocongures breakout interfaces for media type and speed. For example, if you plug a 40G direct attach cable (DAC) with 4x10G far-side
transceivers into a QSFP28 port, the port autocongures in 10g-4x Interface-breakout mode.
RJ-45 ports and ports that are members of a port group do not support breakout auto-conguration. Breakout auto-conguration is
disabled by default.
Enable breakout auto-conguration
OS10(config)# feature auto-breakout
Display breakout auto-conguration
Before you plug a cable in Ethernet port 1/1/25:
OS10# show interface status
------------------------------------------------------------------
Port Description Status Speed Duplex Mode Vlan Tagged-Vlans
------------------------------------------------------------------
Eth 1/1/1 down 0 auto -
Eth 1/1/2 down 0 auto A 1 -
Eth 1/1/25 down 0 auto A 1 -
Eth 1/1/29 down 0 auto A 1 -
After you enter feature auto-breakout and plug a breakout cable in Ethernet port 1/1/25:
OS10# show interface status
------------------------------------------------------------------
Port Description Status Speed Duplex Mode Vlan Tagged-Vlans
------------------------------------------------------------------
Eth 1/1/1 down 0 auto -
Eth 1/1/2 down 0 auto A 1 -
Eth 1/1/25:1 down 0 auto A 1 -
Eth 1/1/25:2 down 0 auto A 1 -
Eth 1/1/25:3 down 0 auto A 1 -
Eth 1/1/25:4 down 0 auto A 1 -
Eth 1/1/29 down 0 auto A 1 -
Reset default conguration
You can clear all congured settings on an Ethernet or Fibre Channel interface and reset the interface to its default settings. By default:
• An Ethernet interface is enabled, using the no shutdown command, and assigned to the default VLAN.
• A Fibre Channel interface is disabled, using theshutdown command.
Restrictions
The default interface command removes all software settings and all L3, VLAN, and port-channel congurations on a port interface.
However, the command does not remove congurations to the interface from other software features, such as VLT. If you do not remove
these congured settings, the command does not execute. For example, if you congure an Ethernet interface as a discovery interface in a
VLT domain and you do not delete this setting, resetting the interface to its default conguration fails:
OS10(config)# vlt-domain 10
OS10(conf-vlt-10)# discovery-interface ethernet 1/1/1
OS10(conf-vlt-10)# exit
OS10(config)# default interface ethernet 1/1/1
86
Interfaces