Reference Guide
Management 1/1/1 10.16.153.226/24 YES manual up up
Vlan 1 unassigned NO unset up down
Vlan 10 unassigned NO unset up down
Vlan 20 unassigned NO unset up down
Vlan 30 unassigned NO unset up down
View VLAN conguration
OS10# show vlan
Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs,
@ – Attached to Virtual Network
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
1 Inactive A Eth1/1/1,1/1/6-1/1/32
10 Inactive
20 Inactive
22 Inactive
23 Active A Eth1/1/2
24 Inactive
25 Inactive
26 Inactive
27 Inactive
28 Inactive
29 Inactive
30 Inactive
Interface commands
channel-group
Assigns an interface to a port-channel group.
Syntax
channel-group channel-number mode {active | on | passive}
Parameters
• channel-number — Enter a port-channel number (1 to 128).
• mode — Sets the LACP actor mode.
• active — Sets channeling mode to active.
• on — Sets channeling mode to static.
• passive — Sets channeling mode to passive.
Default Not congured
Command Mode INTERFACE
Usage Information The no version of this command resets the value to the default, and unassigns the interface from the port-channel
group.
Example
OS10(config)# interface ethernet 1/1/2:1
OS10(conf-if-eth1/1/2:1)# channel-group 20 mode active
Supported Releases 10.3.0E or later
96 Interfaces