Setup Guide

4 Secure the site’s DC power source wires to the other side of the wiring block, see

steps 1 and 3.

WARNING: Do not cross the wires.

5 Insert the DC power connector into the power socket of the DC PSU. Ensure that the

connector pins rmly seat and you hear the click of the power connector’s left and

right levered clamps lock into place.

WARNING: Never try to force the power connector into or out of the DC PSU

power socket.

NOTE: To remove the power connector from a DC PSU, unscrew the thumb screws

and pull the power connector from the DC PSU socket.

Optics installation

WARNING: When working with optical bers, follow all warning labels and always

wear eye protection. Never look directly into the end of a terminated or

unterminated ber or connector as it may cause eye damage.

1 Position the optic so it is in the correct position.

The optic has a key that prevents it from being inserted incorrectly.

2 Insert the optic into the port until it gently snaps into place.

NOTE: When you cable the ports, be sure not to interfere with the airow from

the small vent holes above and below the ports.

Optics removal

Remove an optic by pushing the tab on the optic and sliding the optic from the port.

When removing optics with direct attach cables (DACs) from the port, pull the release tab

rmly and steadily. Before pulling the release tab, you may need to gently push the optic into

the port to ensure that it is seated properly. Do not jerk or tug repeatedly on the tab.

S4112-ON Series Installation