Users Guide

Table Of Contents
Usage
Information
OS10 cannot count both packets and bytes; when you use the count byte options, only bytes
increment. The no version of this command removes the filter.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# deny ipv6 any any capture session 1
Supported
Releases
10.2.0E or later
deny (MAC)
Configures a filter to drop packets with a specific MAC address.
Syntax
deny {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn
[00:00:00:00:00:00] | any} [protocol-number | capture | cos | count | vlan]
Parameters
nn:nn:nn:nn:nn:nn Enter the MAC address of the network from or to which the packets are
sent.
00:00:00:00:00:00 (Optional) Enter which bits in the MAC address must match. If you do not
enter a mask, a mask of 00:00:00:00:00:00 applies.
any (Optional) Set routes which are subject to the filter.
protocol-number (Optional) MAC protocol number identified in the header, from 600 to
ffff.
capture (Optional) Capture packets the filter processes.
cos (Optional) CoS value, from 0 to 7.
count (Optional) Count packets the filter processes.
vlan (Optional) VLAN number, from 1 to 4093.
Default Disabled
Command Mode MAC-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you use the count byte options, only bytes
increment. The no version of this command removes the filter.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# deny any any cos 7
OS10(conf-mac-acl)# deny any any vlan 2
Supported
Releases
10.2.0E or later
deny icmp
Configures a filter to drop all or specific Internet Control Message Protocol (ICMP) messages.
Syntax
deny icmp [A.B.C.D | A.B.C.D/x | any | host ip-address] [[A.B.C.D |
A.B.C.D/x | any | host ip-address] [capture | count | dscp value | fragment
| log]
Parameters
A.B.C.D Enter the IP address in hexadecimal format separated by colons.
A.B.C.D/x Enter the number of bits to match to the IP address.
any (Optional) Enter the keyword any to specify any source or destination IP address.
host ip-address (Optional) Enter the IP address to use a host address only.
capture (Optional) Capture packets the filter processes.
count (Optional) Count packets the filter processes.
byte (Optional) Count bytes the filter processes.
dscp value (Optional) Deny a packet based on the DSCP values, from 0 to 63.
Access Control Lists 1257