Users Guide

Table Of Contents
50:00:d3:10:00:ec:f9:1b
50:00:d3:10:00:ec:f9:05
50:00:d3:10:00:ec:f9:1f
20:35:78:2b:cb:6f:65:57
View FC zoneset configuration
OS10(conf-fc-zoneset-set)# show configuration
!
fc zoneset set
member hba1
member hba2
OS10# show fc zoneset active
vFabric id: 100
Active Zoneset: set
ZoneName ZoneMember
================================================
hba2 *20:01:00:0e:1e:e8:e4:99
20:35:78:2b:cb:6f:65:57
50:00:d3:10:00:ec:f9:05
50:00:d3:10:00:ec:f9:1b
50:00:d3:10:00:ec:f9:1f
hba1 *10:00:00:90:fa:b8:22:19
*21:00:00:24:ff:7b:f5:c8
OS10# show fc zoneset set
ZoneSetName ZoneName ZoneMember
==========================================================
set hba1 21:00:00:24:ff:7b:f5:c8
10:00:00:90:fa:b8:22:19
21:00:00:24:ff:7f:ce:ee
21:00:00:24:ff:7f:ce:ef
hba2 20:01:00:0e:1e:e8:e4:99
50:00:d3:10:00:ec:f9:1b
50:00:d3:10:00:ec:f9:05
50:00:d3:10:00:ec:f9:1f
20:35:78:2b:cb:6f:65:57
F_Port on Ethernet
OS10 supports configuring F_Port mode on an Ethernet port that connects to converged network adapters (CNA). After
enabling F_Port mode, configure a vfabric and apply the vfabric to Ethernet ports connected to CNA. You can configure only
one vfabric in F_Port mode.
You can apply the configured vfabric to multiple Ethernet interfaces. You can also add Ethernet interfaces to a port-channel and
apply the vfabric to the port-channel.
Example configuration
OS10(config)# feature fc domain-id 100
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# name 100
OS10(conf-vfabric-100)# vlan 1023
OS10(conf-vfabric-100)# fcoe fcmap 0xEFC64
OS10(conf-vfabric-100)# zoneset activate set
OS10(conf-vfabric-100)# zone default-zone permit
OS10(conf-vfabric-100)# exit
OS10(config)# interface ethernet 1/1/30
OS10(conf-if-eth1/1/30)# vfabric 100
338
Fibre Channel