Users Guide

Table Of Contents
Parameters server-timeout seconds Enter the number of seconds for the 802.1X server timeout, from 1 to
65535.
Default 30 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x server-timeout 60
Supported
Releases
10.2.0E or later
dot1x timeout supp-timeout
Sets the number of seconds that the device waits for the supplicant to respond to an EAP request frame before the device
retransmits the frame.
Syntax
dot1x timeout supp-timeout seconds
Parameters supp-timeout seconds Enter the number of seconds for the 802.1X supplicant timeout, from 1 to
65535.
Default 30 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout supp-timeout 45
Supported
Releases
10.2.0E or later
dot1x timeout tx-period
Sets the number of seconds that the device waits for a response to an EAP-request/identity frame from the supplicant before
retransmitting the request.
Syntax
dot1x timeout tx-period seconds
Parameters tx-period seconds Enter the number of seconds for the 802.1X transmission timeout, from 1 to
65535.
Default 60 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout tx-period 120
Supported
Releases
10.2.0E or later
Layer 2 443