Users Guide

Common OS10 commands
boot
Configures the OS10 image to use the next time the system boots up.
Syntax
boot system [active | standby]
Parameters
● active — Reset the running image as the next boot image.
● standby — Set the standby image as the next boot image.
Default Not configured
Command Mode EXEC
Usage
Information
Use this command to configure the OS10 image that is reloaded at boot time. Use the show boot
command to verify the next boot image. The boot system command applies immediately.
Example
OS10# boot system standby
Supported
Releases
10.2.0E or later
commit
Commits changes in the candidate configuration to the running configuration.
Syntax
commit
Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
Use this command to save changes to the running configuration. Use the do commit command to save
changes in CONFIGURATION mode.
Example
OS10# commit
Example
(configuration)
OS10(config)# do commit
Supported
Releases
10.2.0E or later
configure
Enters CONFIGURATION mode from EXEC mode.
Syntax
configure {terminal}
Parameters terminal — Enters CONFIGURATION mode from EXEC mode.
Default Not configured
Command Mode EXEC
Usage
Information
Enter conf t for auto-completion.
64 CLI Basics