Users Guide

NOTE: If the next-hop is reachable on the specified VRF instance, the packet is redirected; otherwise, the packet
follows the regular routing flow.
6. Apply the route-map to the interface.
interface interface-type
{ip | ipv6} policy route-map route-map-name
7. View the route-map information.
show route-map
OS10(conf-if-vl-40)# do show route-map
route-map test, permit, sequence 10
Match clauses:
ip address (access-lists): acl1
Set clauses:
ip vrf red next-hop 1.1.1.1 track-id 200
PBR and VLT
When you configure PBR in a VLT setup, configure the same PBR rules on both VLT peers.
In the following example, traffic originates from A and is destined to B. The traffic is redirected to C using a PBR rule through
the VLT port channel. When the VLT port channel interface goes down, the traffic still reaches C through VLTi.
SW1
VLAN configuration
804
Layer 3