API Guide

Processing certificate ...
Host certificate installed successfully.
3. Configure an X.509v3 security profile.
OS10# show crypto cert
-------------------------------------
| Installed non-FIPS certificates |
-------------------------------------
s4048-001
-------------------------------------
| Installed FIPS certificates |
-------------------------------------
OS10# config terminal
OS10(config)# crypto security-profile secure-cluster
OS10(config-sec-profile)# certificate s4048-001
OS10(config-sec-profile)# exit
4. Configure the cluster security profile
OS10(config)# cluster security-profile secure-cluster
OS10(config)# exit
X.509v3 commands
certificate
Configures a certificate and private key pair in an application-specific security profile.
Syntax
certificate certificate-name
Parameters certificate-name — Enter the name of the certificate-key pair as it appears in the show crypto
certs output without the .pem extension.
Default Not configured
Command mode SEC-PROFILE
Usage
information
Use the certificate command to associate a certificate and private key with a security profile. An
application-specific security profile allows you to change the certificate-key pair used by an OS10
application, such as SmartFabric services, without interrupting the service of other mission-critical
applications.
When you install a certificate-key pair, both take the name of the certificate. Enter the certificate-key
pair name without an extension as the certificate-name value. To remove a certificate-key pair from
the profile, enter the no certificate command.
Example
OS10# crypto security-profile secure-radius-profile
OS10(config-sec-profile)# certificate Dell_host1
Supported
releases
10.4.3.0 or later
cluster security-profile
Creates a security profile for a cluster application.
Syntax
cluster security-profile profile-name
Parameters profile-name — Enter the name of the security profile; a maximum of 32 characters.
Default Not configured
Command mode CONFIGURATION
1068 Security