API Guide
ip prefix-list seq deny
Configures a filter to deny route filtering from a specified prefix list.
Syntax
ip prefix-list name seq num deny {A.B.C.D/x [ge | le] prefix-len}
Parameters
● name — Enter the name of the prefix list.
● num — Enter the sequence list number.
● A.B.C.D/x — Enter the source network address and mask in /prefix format (/x).
● ge — Enter to indicate the network address is greater than or equal to the range specified.
● le — Enter to indicate the network address is less than or equal to the range specified.
● prefix-len — Enter the prefix length.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the specified prefix list.
Example
OS10(config)# ip prefix-list seqprefix seq 65535 deny 10.10.10.1/16 ge 10
Supported
Release
10.3.0E or later
ip prefix-list seq permit
Configures a filter to permit route filtering from a specified prefix list.
Syntax
ipv6 prefix-list [name] seq num permit A::B/x [ge | le} prefix-len
Parameters
● name — Enter the name of the prefix list.
● num — Enter the sequence list number.
● A.B.C.D/x — Enter the source network address and mask in /prefix format (/x).
● ge — Enter to indicate the network address is greater than or equal to the range specified.
● le — Enter to indicate the network address is less than or equal to the range specified.
● prefix-len — Enter the prefix length.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the specified prefix list.
Example
OS10(config)# ip prefix-list seqprefix seq 65535 permit 10.10.10.1/16 le
30
Supported
Release
10.3.0E or later
ipv6 access-group
Configures an IPv6 access group.
Syntax
ipv6 access-group access-list-name {in | out}
Parameters
● access-list-name — Enter the name of an IPv6 ACL. A maximum of 140 characters.
● in — Apply the ACL to incoming traffic.
● out — Apply the ACL to outgoing traffic.
Access Control Lists 1141