API Guide

disable
Disables the DHCP server.
Syntax
disable
Parameters None
Default Disabled
Command Mode DHCP
Usage
Information
The no version of this command enables the DHCP server.
Example
OS10(conf-dhcp)# no disable
Supported
Releases
10.2.0E or later
domain-name
Configures the name of the domain where the device is located.
Syntax
domain-name domain-name
Parameters domain-name — Enter the name of the domain with a maximum of 32 characters.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
This is the default domain name that appends to hostnames that are not fully qualified. The no version of
this command removes the configuration.
Example
OS10(conf-dhcp-Dell)# domain-name dell.com
Supported
Releases
10.2.0E or later
dns-server address
Assigns a DNS server to clients based on the address pool.
Syntax
dns-server address [address2...address8]
Parameters
● address — Enter the DNS server IP address that services clients on the subnet in A.B.C.D or A::B
format.
● address2...address8 — (Optional) Enter up to eight DNS server addresses, in order of
preference.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
None
Example
OS10(conf-dhcp-Dell)# dns-server 192.168.1.1
Supported
Releases
10.2.0E or later
230 System management