Connectivity Guide
NOTE: In S5148F-ON, when receive is turned on, it enables decoding of both LLFC and PFC
frames on that port.
• transmit — (Optional) Indicates the local port can send ow control packets to a remote device.
• on — (Optional) When used with receive, allows the local port to receive ow control trac. When used
with
transmit, allows the local port to send ow control trac to the remote device.
• off — (Optional) When used with receive, disables the remote device from sending ow control trac to
the local port. When used with transmit, disables the local port from sending ow control trac to the
remote device.
Default Disabled (off)
Command Mode INTERFACE
Usage Information The no version of this command returns the value to the default.
Example
OS10(conf-if-eth1/1/2)# flowcontrol transmit on
Supported Releases 10.3.0E or later
hardware deep-buer-mode
Congures Deep Buer mode.
Syntax
hardware deep-buffer-mode
Parameters None
Defaults Disabled
Command Modes CONFIGURATION
Usage Information
Deep Buer mode conguration takes eect only after you save it in the startup conguration and reboot the
switch. The no version of this command disables Deep Buer mode.
Example
OS10(config)# hardware deep-buffer-mode
Supported Releases 10.4.3.0 or later
match
Congures match criteria for the QoS policy.
Syntax
match {cos cos-number | ip [access-group name name | dscp dscp-value |
precedence value] | ipv6 [access-group name name [set dscp dscp-value]] | mac
access-group acl-name | not [ip | cos] vlan vlan-id} [set dscp dscp-value]
Parameters
• cos cos—number — Enter a queue number for the CoS match criteria, from 0 to 7.
• ip — Enter the IPv4 match criteria.
• access-group name name — (Optional) Enter the IPv4 access-group name.
• dscp dscp-value — (Optional) Enter a DSCP value for L3 DSCP match criteria, from 0 to 63.
• precedence value — (Optional) Enter a precedence value for L3 precedence match criteria, from 0 to 7.
• ipv6 — Enter the IPv6 match criteria.
1000 Quality of service