Connectivity Guide
Default 32768.
Command Mode VLT-DOMAIN
Usage Information
• After you congure a VLT domain on each peer switch and connect the two VLT peers on each side of the VLT
interconnect, the system elects a primary and secondary VLT peer device. To congure the primary and
secondary roles before the election process, use the primary-priority command. Enter a lower value on
the primary peer and a higher value on the secondary peer. If the primary peer fails, the secondary peer (with
the higher priority) takes the primary role. If the primary peer (with the lower priority) later comes back online,
it is assigned the secondary role; there is no preemption.
• If the priority values congured on the two VLT peers are equal, VLT uses the default primary election
mechanism based on the values of the system MAC addresses of the two nodes. The VLT peer with the lowest
system MAC address assumes the primary role.
• If the heartbeat is up and the VLTi link goes down between the VLT peers, both the VLT peers retain their
primary and secondary roles. However, the VLT LAG on the secondary VLT peer shuts down.
NOTE: When you congure a priority for VLT peers using this command, the conguration is not
eective immediately. The primary priority conguration comes into eect the next time election is
triggered.
Example
OS10(conf-vlt-1)#primary-priority 2
Supported Releases 10.4.1.0 or later
show spanning-tree virtual-interface
Displays STP , RPVST+, and MSTP information specic to VLT.
Syntax
show spanning-tree virtual-interface [detail]
Parameters detail—(Optional) Displays detailed output.
Default Not congured
Command Mode EXEC
Usage Information None
Example
OS10# show spanning-tree virtual-interface
VFP(VirtualFabricPort) of RSTP 1 is Designated Forwarding
Edge port: No (default)
Link type: point-to-point (auto)
Boundary: No, Bpdu-filter: Disable, Bpdu-Guard: Disable, Shutdown-on-Bpdu-Guard-violation: No
Root-Guard: Disable, Loop-Guard: Disable
Bpdus (MRecords) Sent: 11, Received: 7
Interface Designated
Name PortID Prio Cost Sts Cost Bridge ID PortID
---------------------------------------------------------------------------------------------
VFP(VirtualFabricPort) 0.1 0 1 FWD 0 32768 0078.7614.6062 0.1
OS10# show spanning-tree virtual-interface
VFP(VirtualFabricPort) of vlan 100 is Designated Blocking
Edge port: No (default)
Link type: point-to-point (auto)
Boundary: No, Bpdu-filter: Disable, Bpdu-Guard: Disable, Shutdown-on-Bpdu-Guard-violation: No
Root-Guard: Disable, Loop-Guard: Disable
Bpdus (MRecords) Sent: 7, Received: 9
Interface Designated
Name PortID Prio Cost Sts Cost Bridge ID PortID
---------------------------------------------------------------------------------------------
VFP(VirtualFabricPort) 0.1 0 1 BLK 0 4196 90b1.1cf4.a602 0.1
Example (detail)
OS10# show spanning-tree virtual-interface detail
Port 1 (VFP(VirtualFabricPort)) of RSTP 1 is designated Forwarding
Port path cost 1, Port priority 0, Port Identifier 0.1
Virtual Link Trunking 1061