Connectivity Guide

sensor-path
Congures the path to a YANG container from which data is streamed.
NOTE: This command is not supported in release 10.4.3.0.
Syntax
sensor-path yang-path
Parameters yang-path — Enter the YANG path. See YANG-modeled telemetry data for the YANG paths for telemetry data
collection.
Default Not congured
Command mode SENSOR-GROUP
Usage information The data in the specied YANG path is streamed to a congured destination at a specied interval or in near real-
time when an event occurs. You can enter a sensor path at any level in the container hierarchy. Data from all
containers in the hierarchy below this path is streamed to destination devices. To congure multiple sensor paths in
a sensor group, re-enter the command.
Example
OS10(conf-telemetry)# sensor-group interfaces
OS10(conf-telemetry-sg-interfaces)# sensor-group dell-base-if-cmn/if/
interfaces-state/interface
OS10(conf-telemetry-sg-interfaces)# sensor-group dell-base-cmn/if/interfaces/
interface/member-ports
Supported releases 10.4.3.0 or later
show telemetry
Displays the congured destination-group, sensor-group, and subscription proles for streaming telemetry.
Syntax
show telemetry [destination-group [group-name] | sensor-group [group-name] |
subscription-profile [profile-name]]
Parameters
• destination-group — Display only destination groups or a specied group.
• sensor-group — Display only sensor groups or a specied group.
• subscription-profile — Display only subscription proles or a specied prole.
Default Display all destination-group, sensor-group, and subscription congurations.
Command mode EXEC
Usage information Use the show telemetry command to verify the congured destination devices, sensor data sources, and
subscription proles.
Examples
OS10# show telemetry destination-group
Telemetry Status : enabled
-- Telemetry Destination Groups --
Group : dest1
Destination : 10.11.56.204 Port : 40001
OS10# show telemetry sensor-group
Telemetry Status : enabled
Telemetry 1139