Connectivity Guide
no shutdown
switchport access vlan 1
Congure range of VLANs
OS10(config)# interface range vlan 1-100
OS10(conf-range-vl-1-100)#
Congure range of port channels
OS10(config)# interface range port-channel 1-25
OS10(conf-range-po-1-25)#
Switch-port proles
A port prole determines the enabled front-panel ports and supported breakout modes on Ethernet and unied ports. Change the port
prole on a switch to customize uplink and unied port operation, and the availability of front-panel data ports.
To change the port prole at the next reboot, use the switch-port-profile command with the desired prole, save it to the startup
conguration, and use the reload command to apply the changes.
1 Congure a platform-specic port prole in CONFIGURATION mode. For a standalone switch, enter 1/1 for node/unit.
switch-port-profile node/unit profile
2 Save the port prole change to the startup conguration in EXEC mode.
write memory
3 Reload the switch in EXEC mode.
reload
The switch reboots with the new port conguration and resets the system defaults, except for the switch-port prole and these congured
settings:
• Management interface 1/1/1 conguration
• Management IPv4/IPv6 static routes
• System hostname
• Unied Forwarding Table (UFT) mode
• ECMP maximum paths
You must manually recongure other settings on a switch after you apply a new port prole and reload the switch.
NOTE
: After you change the switch-port prole, do not immediately back up and restore the startup le without using the
write memory command and reloading the switch using the reload command. Otherwise, the new prole does not take
eect.
Congure port prole
OS10(config)# switch-port-profile 1/1 profile-6
OS10(config)# exit
OS10# write memory
OS10# reload
Verify port prole
OS10(config)# show switch-port-profile 1/1
| Node/Unit | Current | Next-boot | Default |
|-------------+-------------------+-------------------|
| 1/1 | profile-2 | profile-2 | profile-1 |
Supported Profiles:
profile-1
profile-2
profile-3
profile-4
160
Interfaces