Connectivity Guide

• ethertype — Enables Ethernet type information in the hash calculation.
Default
• ip-selelection—source—ip dest-ip vlan-id l4–source-port l4–dest-port ipv4
protocol
• ipv6-selection—source—ipv6 dest-ipv6 vlan—id l4–source-port l4–dest-port ipv6
protocol
•
mac-selection—source—mac destination—mac vlan-id ethertype
• tcp-udp-selection—l4–source-port l4–dest-port
Command Mode CONFIGURATION
Usage Information
• IPv4– selection: source-ip destination-ip protocol vlan-id l4-destination-port l4-
source-port
• IPv6 destination address: source-ip destination-ip protocol vlan-id l4-destination-
port l4-source-port
•
MAC parameters: source-mac destination-mac ethertype vlan-id
• TCP/UDP parameters: l4-destination-port l4-source-port
The no version of this command resets the value to the default.
Example (Ingress)
OS10(config)# load-balancing ingress-port enable
Example (IP
Selection)
OS10(config)# load-balancing ip-selection destination-ip source-ip
Supported Releases 10.2.0E or later
show enhanced-hashing resilient-hashing
Displays the status of the enhanced-hashing command.
Syntax
show enhanced-hashing resilient-hashing {lag | ecmp}
Parameters lag | ecmp—Enter the keyword to view enhanced-hashing for a port channel or ECMP group.
Default Disabled
Command Mode EXEC
Usage Information None
Example
OS10# show enhanced-hashing resilient-hashing lag
Resilient Hashing Configuration For LAG:
----------------------------------------
LAG Resilient hashing : Disabled
OS10# show enhanced-hashing resilient-hashing ECMP
Resilient Hashing Configuration For ECMP:
----------------------------------------------
ECMP Resilient hashing : Disabled
Supported Releases 10.4.3.0 or later
500 Layer 3