Connectivity Guide

--------------------------------------------------------------
199.205.134.103 42 0x80000001 12 ethernet1/1/3
202.254.156.15 54 0x80000001 12 ethernet1/1/3
Enable Passive Interfaces
A passive interface is one that does not send or receive routing information. Conguring an interface as a passive interface suppresses both
the receiving and sending routing updates.
Although the passive interface does not send or receive routing updates, the network on that interface is included in OSPF updates sent
through other interfaces. You can remove an interface from passive interfaces using the no ipv6 ospf passive command.
1 Enter an interface type in INTERFACE mode.
interface ethernet node/slot/port[:subport]
2 Congure the interface as a passive interface in INTERFACE mode.
ipv6 ospf passive
Congure Passive Interfaces
OS10(config)# interface ethernet 1/1/6
OS10(conf-if-eth1/1/6)# ipv6 ospf passive
View Passive Interfaces
OS10# show running-configuraiton
!!!
!!
interface ethernet1/1/1
ip address 10.10.10.1/24
no switchport
no shutdown
ipv6 ospf 100 area 0
ipv6 ospf passive
!!
!
Interface OSPFv3 Parameters
Interface parameter values must be consistent across all interfaces to avoid routing errors. For example, set the same time interval for the
hello packets on all routers in the OSPF network to prevent misconguration of OSPF neighbors.
1 Enter the interface to change the OSPFv3 parameters in CONFIGURATION mode.
interface interface-name
2 Change the cost associated with OSPFv3 trac on the interface in INTERFACE mode, from 1 to 65535, default depends on the
interface speed.
ipv6 ospf cost
3 Change the time interval the router waits before declaring a neighbor dead in INTERFACE mode, from 1 to 65535, default 40. The
dead interval must be four times the hello interval. The dead interval must be the same on all routers in the OSPFv3 network.
ipv6 ospf dead-interval seconds
4 Change the time interval in seconds between hello-packet transmission in INTERFACE mode, from 1 to 65535, default 10. The hello
interval must be the same on all routers in the OSPFv3 network.
ipv6 ospf hello-interval seconds
5 Change the priority of the interface, which determines the DR for the OSPFv3 broadcast network in INTERFACE mode, from 0 to
255, default 1.
ipv6 ospf priority number
570
Layer 3