Connectivity Guide
Parameters
loopback
number
Enter the Loopback interface used as the source interface of a VXLAN virtual tunnel,
from 0 to 16383.
Default Not congured
Command mode NVE-INSTANCE
Usage information
The IP address of the Loopback interface serves as the source IP address in encapsulated packets transmitted
from the switch as an NVE VTEP.
• The Loopback interface must have an IP address congured. The Loopback IP address must be reachable from
the remote VTEP.
• You cannot change the source interface if at least one VXLAN virtual network ID (VNID) is congured for the
NVE instance.
Use this command in NVE mode to override a previously congured value and recongure the source IP address.
The no version of this command removes the congured value.
Examples
OS10(config-nve)# source-interface loopback 1
Supported releases 10.4.2.0 or later
virtual-network
Creates a virtual network for VXLAN tunneling.
Syntax
virtual-network vn-id
Parameters
vn-id
Enter the virtual-network ID, from 1 to 65535.
Default Not congured
Command mode CONFIGURATION
Usage information The virtual network operates as a L2 bridging domain. To add a VXLAN to the virtual network, use the vxlan-
vni command. The no version of this command removes the congured virtual network.
Example
OS10(config)# virtual-network 1000
OS10(config-vn)#
Supported releases 10.4.2.0 or later
virtual-network untagged-vlan
Congures a dedicated VLAN for internal use to transmit untagged trac on member ports in virtual networks on the switch.
Syntax
virtual-network untagged-vlan vlan-id
Parameters
id
Enter the reserved untagged VLAN ID, from 1 to 4093.
Default Not congured
Command mode CONFIGURATION
VXLAN 703