Connectivity Guide
To congure an NSX controller-provisioned VXLAN:
• Congure the controller and the interfaces to be managed by the controller, in the OS10 VTEPs
• Congure the NSX controller in VMware vCenter. For more information about conguring the NSX controller using the GUI, see the
Congure and control VXLAN from the VMware vCenter.
You must congure an OS10 VTEP with the controller conguration so that the VTEP can communicate with the NSX controller. The NSX
controller handles congurations and control plane operations in the VXLAN environment.
VTEP 1
1 Congure the OSPF protocol in the underlay.
OS10# configure terminal
OS10(config)# router ospf 1
OS10(config)# exit
OS10(config)# interface ethernet 1/1/55:1
OS10(config-if-eth1/1/55:1)# no switchport
OS10(config-if-eth1/1/55:1)# ip ospf 1 area 0.0.0.0
OS10(config-if-eth1/1/55:1)# exit
2 Congure a Loopback interface.
OS10(config)# interface loopback 1
OS10(config-if-lo-1)# no shutdown
OS10(config-if-lo-1)# ip address 200.0.0.1/32
OS10(config-if-lo-1)# exit
3 Create an NVE instance and congure the Loopback interface as the VXLAN source tunnel interface.
OS10(config)# nve
OS10(config-nve)# source-interface loopback 1
770
VXLAN