Reference Guide
• key authentication-key — (Optional) Enter the authentication key used to authenticate the switch on
the server (up to 42 characters; default radius_secure).
Default Not congured
Command Mode CONFIGURATION
Usage Information The authentication key must match the key congured on the RADIUS server. Congure global settings for the
timeout and retransmit attempts allowed on RADIUS servers by using the radius-server retransmit and
radius-server timeout commands. The no version of this command removes a RADIUS server
conguration.
Example
OS10(config)# radius-server host 1.5.6.4 key secret1
Supported Releases 10.2.0E or later
radius-server retransmit
Congures the number of authentication attempts allowed on RADIUS servers.
Syntax
radius-server retransmit retries
Parameters retries — Enter the number of retry attempts (0 to 100).
Default An OS10 switch retransmits a RADIUS authentication request three times.
Command Mode CONFIGURATION
Usage Information Use this command to globally congure the number of retransmit attempts allowed for authentication requests on
RADIUS servers. The no version of this command resets the value to the default.
Example
OS10(config)# radius-server retransmit 50
Supported Releases 10.2.0E or later
radius-server timeout
Congures the timeout used to resend RADIUS authentication requests.
Syntax
radius-server timeout seconds
Parameters seconds — Enter the time in seconds for retransmission (0 to 1000).
Default An OS10 switch stops sending RADIUS authentication requests after ve seconds.
Command Mode CONFIGURATION
Usage Information Use this command to globally congure the timeout value used on RADIUS servers. The no version of this
command resets the value to the default.
Example
OS10(config)# radius-server timeout 360
Supported Releases 10.2.0E or later
470 System management