Reference Guide

ipv6 prex-list seq deny

Congures a lter to deny route ltering from a specied prex-list.

Syntax

ipv6 prefix-list [name] seq num deny {A::B/x [ge | le] prefix-len}

Parameters

• name — (Optional) Enter the name of the IPv6 prex-list.

• num — Enter the sequence number of the specied IPv6 prex-list.

• A::B/x — Enter the IPv6 address and mask in /prex format (/x).

• ge — Enter to indicate the network address is greater than or equal to the range specied.

• le — Enter to indicate the network address is less than or equal to the range specied.

• prefix-len — Enter the prex length.

Defaults Not congured

Command Mode CONFIGURATION

Usage Information The no version of this command removes the specied prex-list.

Example

OS10(config)# ipv6 prefix-list TEST seq 65535 deny AB20::1/128 ge 10

Supported Release 10.3.0E or later

ipv6 prex-list seq permit

Congures a lter to permit route ltering from a specied prex-list.