Reference Guide
Example
OS10(config)# system identifier 1
Supported Releases 10.3.0E or later
terminal
Sets the number of lines to display on the terminal and enables logging.
Syntax
terminal {length lines | monitor}
Parameters
• length lines — Enter the number of lines to display on the terminal (0 to 512, default 24).
• monitor — Enables logging on the terminal.
Default 24 terminal lines
Command Mode EXEC
Usage Information Enter zero (0) for the terminal to display without pausing.
Example
OS10# terminal monitor
Supported Releases 10.2.0E or later
traceroute
Displays the routes that packets take to travel to an IP address.
Syntax
traceroute [vrf management] host [-46dFITnreAUDV] [-f first_ttl] [-g gate,...]
[-i device] [-m max_ttl] [-N squeries] [-p port] [-t tos] [-l flow_label] [-w
waittime] [-q nqueries] [-s src_addr] [-z sendwait] [--fwmark=num] host
[packetlen]
Parameters
• vrf management— (Optional) Traces the route to an IP address in the management VRF instance.
• host — Enter the host to trace packets from.
• -i interface — (Optional) Enter the IP address of the interface through which traceroute sends packets.
By default, the interface is selected according to the routing table.
• -m max_ttl — (Optional) Enter the maximum number of hops (maximum time-to-live value) that
traceroute probes (default 30).
• -p port — (Optional) Enter a destination port:
– For UDP tracing, enter the destination port base that traceroute uses (the destination port number is
incremented by each probe).
– For ICMP tracing, enter the initial ICMP sequence value (incremented by each probe).
– For TCP tracing, enter the (constant) destination port to connect.
– -P protocol — (Optional) Use a raw packet of the specied protocol for traceroute. Default protocol is
253 (RFC 3692).
– -s source_address — (Optional) Enter an alternative source address of one of the interfaces. By
default, the address of the outgoing interface is used.
– -q nqueries — (Optional) Enter the number of probe packets per hop (default 3).
– -N squeries — (Optional) Enter the number of probe packets that are sent out simultaneously to
accelerate traceroute (default 16).
Getting Started 69