Connectivity Guide

Table Of Contents
show ipv6 ospf interface
Displays the congured OSPFv3 interfaces. You must enable OSPFv3 to display the output.
Syntax
show ipv6 ospf interface interface [vrf vrf-name]
Parameters
interface — (Optional) Enter the interface information:
ethernet — Physical interface, from 1 to 48.
port-channel — Port-channel interface, from 1 to 128.
vlan — VLAN interface, from 1 to 4093.
vrf vrf-name — (Optional) Enter the keyword vrf followed by the name of the VRF to display the
congured OSPFv3 enabled interfaces in that VRF.
Default Not congured
Command Mode EXEC
Example
OS10# show ipv6 ospf interface
ethernet1/1/1 is up, line protocol is up
Link Local Address fe80::20c:29ff:fe0a:d59/64, Interface ID 5
Area 0.0.0.0, Process ID 200, Instance ID 0, Router ID 10.0.0.2
Network Type broadcast, Cost: 1
Transmit Delay is 1 sec, State BDR, Priority 1
BFD enabled(Interface level) Interval 300 Min_rx 300 Multiplier 3 Role Active
Designated Router on this network is 2.2.2.2
Backup Designated router on this network is 10.0.0.2 (local)
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 2.2.2.2(Designated Router)
Supported Releases 10.3.0E or later
show ipv6 ospf neighbor
Displays a list of OSPFv3 neighbors connected to the local router.
Syntax
show ipv6 ospf [vrf vrf-name] neighbor
Parameters
vrf vrf-name — Enter the keyword vrf followed by the name of the VRF to display a list of OSPFv3
neighbors in that VRF.
Default Not congured
Command Mode EXEC
Usage Information
Neighbor ID—Displays the neighbor router ID.
Pri—Displays the priority assigned neighbor.
State—Displays the OSPF state of the neighbor.
Dead Time—Displays the expected time until the system declares the neighbor dead.
Interface ID—Displays the neighbor interface ID
Interface—Displays the interface type, node/slot/port or number information.
Example
OS10(conf-if-eth1/1/1)# show ipv6 ospf neighbor
Neighbor ID Pri State Dead Time Interface ID Interface
486 Layer 3